Attaching GO! Chassi to an installed Chassi Hitch

1. Roll the collapsed GO! Chassi to the rear of our Vehicle (which is parked on level ground) and position it perpendicular to the Chassi Hitch.

2. Turn the Hand Crank clockwise so the bottom of the Chassi Tongue is higer than the Chassi Hitch.

3. Maneuver the unit so the Tongue is directly above the Hitch and turn the Hand Crank counter clockwise, lowering the Tongue into the Hitch. 

If equipped with the Chassi All Terrain Kit, waggle the Pull Handle from side to side simultaneously as you turn the Hand Crank.

4. When the Stabilizing Plates of the Tongue and the Chassi  are touching, push the 5/8” Hitch Pin through the thru-holes on the sides of the Hitch and secure by snapping in the Hitch Pin Clip.  Continue to turn the Hand Crank counter clockwise until the Bumpers of the Lower Rail touch the Upper Rail. Stow the Flip Handle.

5. If equipped with the Chassi Taillight Kit, plug the four pin connector to your Vehicle Hitch Electrical system. Test to make sure the Stop, Tail and Turn lights function properly.

Detaching GO! Chassi to an installed Chassi Hitch

5. If equipped with Chassi Taillight Kit, unplug the four pin connector from your Vehicle Hitch Electrical system.

4. Remove the Hitch Pin Clip and the 5/8” Hitch Pin from the Chassi Receiver.

3. Turn the Hand Crank clockwise until the Tongue is above the Hitch.

2. Position the unit so that no part of the Tongue is above the Hitch.

1. Turn the Hand Crank counter clockwise, lowering the unit until the Bumpers of the Lower Rail touch the Upper Rail. Stow the Flip Handle and roll the GO! Chassi into service.